2023 Latest Cisco 200-301 Real Exam Dumps PDF
200-301 Exam Dumps, 200-301 Practice Test Questions
Target Audience for Cisco 200-301 Exam
The 200-301 exam is intended for those practitioners who are new to the IT sector and looking to advance their career in this industry. This certification test improves the general expertise of the support specialists who are responsible for the fundamental design, deployment, and maintenance of Cisco network ecosystems. In addition, Cisco 200-301 is an ideal exam for the Network Engineers, Administrators, Support Technicians, and Help Desk Specialists.
Cisco has been shaping the IT industry for decades now. And with the recently introduced job-oriented certifications, you have one of the easiest paths to launch a successful IT career if you get the right skills. One of them is the Cisco 200-301 exam.
NEW QUESTION 400
Refer to the exhibit.
On R1 which routing protocol is in use on the route to192.168.10.1?
- A. OSPF
- B. IGRP
- C. RIP
- D. EIGRP
Answer: D
NEW QUESTION 401
Refer to the exhibit.
An engineer configured NAT translations and has verified that the configuration is correct.
Which IP address is the source IP?
- A. 10.4.4.5
- B. 10.4.4.4
- C. 172.23.104.4
- D. 172.23.103.10
Answer: C
NEW QUESTION 402
Refer to the exhibit. What is the result if Gig1/11 receives an STP BPDU?
- A. The port transitions to STP blocking
- B. The port goes into error-disable state
- C. The port transitions to the root port
- D. The port immediately transitions to STP forwarding.
Answer: B
Explanation:
BPDU Guard feature protects the port from receiving STP BPDUs, however the port can transmit STP BPDUs. When a STP BPDU is received on a BPDU Guard enabled port, the port is shutdown and the state of the port changes to ErrDis (Error-Disable) state.
NEW QUESTION 403
Drag and drop the characteristics of network architectures from the left onto the type of architecture on the right.
Answer:
Explanation:
NEW QUESTION 404
Refer to the exhibit.
Which action is expected from SW1 when the untagged frame is received on the GigabitEthernet0/1 interface?
- A. The frame is processed in VLAN 5.
- B. The frame is processed in VLAN 11
- C. The frame is dropped
- D. The frame is processed in VLAN 1
Answer: A
NEW QUESTION 405
When configuring a WLAN with WPA2 PSK in the Cisco Wireless LAN Controller GUI, which two formats are available to select? (Choose two)
- A. binary
- B. ASCII
- C. decimal
- D. hexadecimal
- E. base64
Answer: B,D
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_01010001.html
NEW QUESTION 406
Drag and drop the WLAN components from the left onto the correct descriptions on the right.
Answer:
Explanation:
NEW QUESTION 407
Refer to the exhibit.
A packet is being sent across router R1 to host 172.163.3.14. To which destination does the router send the packet?
- A. 207.165.200.246 via Serial0/1/0
- B. 207.165.200.254 via Serial0/0/1
- C. 207.165.200.250 via Serial/0/0/0
- D. 207.165.200.254 via Serial0/0/0
Answer: B
NEW QUESTION 408
Which key function is provided by the data plane?
- A. Originating packets
- B. Forwarding traffic to the next hop
- C. Making routing decisions
- D. Exchanging routing table data
Answer: B
NEW QUESTION 409
Drag and Drop Question
Drag and drop the TCP or UDP details from the left onto their corresponding protocols on the right.
Answer:
Explanation:
NEW QUESTION 410
Refer to Exhibit.
The loopback1 interface of the Atlanta router must reach the loopback3 interface of the Washington router.
Which two static host routes must be configured on the NEW York router? (Choose two)
- A. ipv6 route 2000::1/128 s0/0/1
- B. ipv6 route 2000::1/128 2012::2
- C. ipv6 route 2000::3/128 2023::3
- D. ipv6 route 2000::3/128 s0/0/0
- E. ipv6 route 2000::1/128 2012::1
Answer: A,B
NEW QUESTION 411
Refer to the exhibit.
If OSPF Is running on this network, how does Router2 handle traffic from Site B to 10.10.13.128/25 at Site A?
- A. It sends packets out of interface FaO/2.
- B. It sends packets out of interface Fa0/1.
- C. It is unreachable and discards the traffic.
- D. It load-balances traffic out of Fa0/1 and Fa0/2.
Answer: C
NEW QUESTION 412
Drag and chop the TCP/IP protocols from the left onto their primary transmission protocols on the right.
Answer:
Explanation:
NEW QUESTION 413
Refer to the exhibit. If the network environment is operating normally, which type of device must be connected to interface FastEthernet 0/1?
- A. DHCP client
- B. access point
- C. PC
- D. router
Answer: D
Explanation:
Routers are networki devices that are under Administrative control. Hence, they are configured Trusted in DAI and DHCP Snooping.
NEW QUESTION 414
A network administrator must to configure SSH for remote access to router R1 The requirement is to use a public and private key pair to encrypt management traffic to and from the connecting client.
Which configuration, when applied, meets the requirements?
- A. Option C
- B. Option A
- C. Option B
- D. Option D
Answer: A
NEW QUESTION 415
Refer to the exhibit.
Users need to connect to the wireless network with IEEE 802. 11r-compatible devices. The connection must be maintained as users travel between floors or to other areas in the building What must be the configuration of the connection?
- A. Enable Fast Transition and select the FT 802.1x option.
- B. Select the WPA Policy option with the CCKM option.
- C. Disable AES encryption.
- D. Enable Fast Transition and select the FT PSK option.
Answer: A
NEW QUESTION 416
How does HSRP provide first hop redundancy?
- A. It load-balances traffic by assigning the same metric value to more than one route to the same destination m the IP routing table.
- B. It uses a shared virtual MAC and a virtual IP address to a group of routers that serve as the default gateway for hosts on a LAN
- C. It load-balances Layer 2 traffic along the path by flooding traffic out all interfaces configured with the same VLAN.
- D. It forwards multiple packets to the same destination over different routed links n the data path
Answer: B
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipapp_fhrp/configuration/xe-16/fhp-xe-16-book/fhp-hsrp-mgo.html
NEW QUESTION 417
Refer to the exhibit.
Only four switches are participating in the VLAN spanning-tree process.
Branch-1 priority 614440
Branch-2: priority 39082416
Branch-3: priority 0
Branch-4: root primary
Which switch becomes the permanent root bridge for VLAN 5?
- A. Branch-3
- B. Branch-1
- C. Branch-4
- D. Branch-2
Answer: A
NEW QUESTION 418
Which level of severity must be set to get informational syslogs?
- A. alert
- B. debug
- C. critical
- D. notice
Answer: B
Explanation:
Specifying a level causes messages at that level and numerically lower levels to be displayed at the destination.
From Table 3 : informational level = 6, debugging level = 7, notice/notifications level = 5
https://www.cisco.com/c/en/us/td/docs/routers/access/wireless/software/guide/SysMsgLogging.ht ml
NEW QUESTION 419
A router running EIGRP has learned the same route from two different paths. Which parameter does the router use to select the best path?
- A. metric
- B. as-path
- C. cost
- D. administrative distance
Answer: A
Explanation:
If a router learns two different paths for the same network from the same routing protocol, it has to decide which route is better and will be placed in the routing table. Metric is the measure used to decide which route is better (lower number is better). Each routing protocol uses its own metric.
For example, RIP uses hop counts as a metric, while OSPF uses cost.
https://study-ccna.com/administrative-distance-metric/
NEW QUESTION 420
Refer to the exhibit.
Shortly after SiteA was connected to SiteB over a new single-mode fiber path users at SiteA report intermittent connectivity issues with applications hosted at SiteB What is the cause of the intermittent connectivity issue?
- A. The sites were connected with the wrong cable type
- B. An incorrect SFP media type was used at SiteA
- C. High usage is causing high latency
- D. Interface errors are incrementing
Answer: C
NEW QUESTION 421
......
Exam Preparation
Thorough preparation is a key point of exam success. To help the candidates in their preparation process, Cisco proposes the Implementing & Administering Cisco Solutions training course. It combines lectures, self-study elements, and hands-on labs to equip them with the skills in installing, configuring, verifying, and operating basic IPv4 & IPv6 networks. Moreover, the students will learn how to configure the network components, including wireless LAN controllers, switches, routers as well as find out how to manage different network devices. Apart from the official course, the learners can also explore other online resources (for instance, video tutorials from various reputable websites). On the other hand, they can think about using different books. In fact, there are numerous tools to prepare for Cisco 200-301, just choose something that will match your needs.
PDF (New 2023) Actual Cisco 200-301 Exam Questions: https://pass4sure.practicedump.com/200-301-exam-questions.html